2000 honda accord water pump

Do It Yourself Honda Accord

If installing a new pump, the installation of a new O-ring is suggested. Hand tighten all the screws then apply the final torque with a 3/8″ socket wrench. Do not over torque. The water pump is typically bolted to the front of the engine. The replacement treatment will differ depending on whether the pump is driven by the timing belt, the serpentine belt, or chain. wow, took me that long just to get the crankshaft screw off.

For applications where the water pump is driven by the timing belt, the timing belt have to be removed. Normally, this needs removal of the crankshaft pulley-block, timing belt covers, and also timing belt tensioner. When the brand-new pump is installed, brand-new coolant is included back while hemorrhaging the air conditioning system of any air. The engine is then run as well as offered normal operating temperature to check for leaks as well as make certain typical operating temperature. The valve cover need to be removed or raised to remove the upper timing belt cover.

Still, often I obtain a little air which functions its way out over a pair days of driving. You ought to have hemorrhaged the air out of the system utilizing the bleeder at the thermostat real estate.

The gasket surface need to be cleansed as well as the pump mounting surface inspected. A brand-new gasket, rubber seal, or RTV sealant, as called for, is set up and after that the new pump. The screws are torqued in turn using an adjusted inch extra pound torque wrench. The dealership claims 5 hours labor for whole task. He stated he will spend for half the labor If I spend for components at his cost. Under $100 for parts as well as 2.5 hours labor is my end.

2000 honda accord water pump

Eventually, the bearing or seal can put on and also leakage or damages the impeller. Lots of water pumps have weep holes near the pump bearing. If you see considerable leakage from that weep opening, it is time to change the pump. I have a 98 Honda Accord DX on the upper right-hand man side of the water pump there is an Opening that is threded what goes there? mine as well as leaking from that spot.i just got the auto and also understand nothing about it in any way. Eliminate the bolts that protect the upper timing belt cover and also remove the cable harness recessed in the cover. Eliminate the crankshaft sheave screw with a breaker bar affixed to a long expansion to remove the fender.

The belt substitute period is either 90,000 or 105,000 miles based on the specific version year. Examine the proprietor’s handbook for the certain solution interval. If the mileage is below the limit however the automobile is over 7 years old, consider carrying out a substitute as preventative maintenance.

admwp